Getting the following error messages on the ASA:
Tunnel manager has failed to establish an L2L SA. All configured IKE versions failed to establish the tunnel. Map Tag= Outside_map0. Map Sequence Number = 3
6 | Aug 21 2018 | 12:51:11 | IP = 138.91.164.253, Warning: Ignoring IKE SA (dst) without VM bit set | |||||||||
4 | Aug 21 2018 | 12:51:11 | IKEv1 was unsuccessful at setting up a tunnel. Map Tag = Outside_map0. Map Sequence Number = 3. | |||||||||
3 | Aug 21 2018 | 12:51:11 | Tunnel Manager has failed to establish an L2L SA. All configured IKE versions failed to establish the tunnel. Map Tag= Outside_map0. Map Sequence Number = 3. | |||||||||
4 | Aug 21 2018 | 12:51:12 | Local:50.226.33.2:500 Remote:138.91.164.253:500 Username:138.91.164.253 IKEv2 Negotiation aborted due to ERROR: Auth exchange failed | |||||||||
4 | Aug 21 2018 | 12:51:12 | IKEv2 was unsuccessful at setting up a tunnel. Map Tag = Outside_map0. Map Sequence Number = 3. | |||||||||
4 | Aug 21 2018 | 12:51:12 | Tunnel Manager dispatching a KEY_ACQUIRE message to IKEv1 after a failed attempt.. Map Tag = Outside_map0. Map Sequence Number = 3. | |||||||||
5 | Aug 21 2018 | 12:51:12 | Tunnel Manager dispatching a KEY_ACQUIRE message to IKEv2. Map Tag = Outside_map0. Map Sequence Number = 3. | |||||||||
5 | Aug 21 2018 | 12:51:12 | Local:50.226.33.2:500 Remote:138.91.164.253:500 Username:Unknown IKEv2 Received request to establish an IPsec tunnel; local traffic selector = Address Range: 10.0.126.1-10.0.126.1 Protocol: 0 Port Range: 0-65535; remote traffic selector = Address Range: 192.168.5.13-192.168.5.13 Protocol: 0 Port Range: 0-65535 | |||||||||
I've read thru a number of different Azure documents trying to get this to work. I'm not at all proficient in Azure, I'm a Cisco Route Switch guy. Need to know how to check the IPSec settings on the Azure side.