Hi,
We have setup a Azure site to site VPN connectivity for a Client . The client is using a cisco router to connect (Cisco ISR IOS 15.1).
The required GW details has been exchanged along with the *.cfg scripts. for the ip route we have provide the client with our ILB ip with CIDR \27.
After configuration completed at the client end , we are not able to see the status as connected. To analyze we have gathered some logs at our end where
we could see
Failure type: IKE/Authip Main Mode Failure
Type specific info:
Failure error code:0x000035ed
Negotiation timed out
Failure point: Local
Flags: 0x00000000
Keying module type: IKEv2
MM State: Initial state, no packets sent
MM SA role: Initiator
MM auth method: Unknown
We have used the 'Virtural Network (classic)' to configure.
Any help/info greatly appreciated.
We have setup a Azure site to site VPN connectivity for a Client . The client is using a cisco router to connect (Cisco ISR IOS 15.1).
The required GW details has been exchanged along with the *.cfg scripts. for the ip route we have provide the client with our ILB ip with CIDR \27.
After configuration completed at the client end , we are not able to see the status as connected. To analyze we have gathered some logs at our end where
we could see
Failure type: IKE/Authip Main Mode Failure
Type specific info:
Failure error code:0x000035ed
Negotiation timed out
Failure point: Local
Flags: 0x00000000
Keying module type: IKEv2
MM State: Initial state, no packets sent
MM SA role: Initiator
MM auth method: Unknown
We have used the 'Virtural Network (classic)' to configure.
Any help/info greatly appreciated.