Quantcast
Channel: Azure Networking (DNS, Traffic Manager, VPN, VNET) forum
Viewing all articles
Browse latest Browse all 6513

Configure the Azure Network Gateway to route trafic to desired IP

$
0
0

Hi All,

We decided to use a VPN/Firewall virtual  appliance on Azure. The following picture shows our target architecture.

- We have a VNET on Azure with 4 subnets (Subnet01..04)

- We create our VPN/FW virtual appliance (with 4 NICs) on Subnet 04, and we connected it to the 3 remaining subnets.

- We configured subnets (Subnet01, 02, 03) to route traffic by default to the virtual appliance IP (OK)

- We configured the Subnet04 to route trafic to the gateway (OK)

--> Now we get into an issue. We have no control on the Gateway, we cannot configure the gateway to route traffic to to the virtual appliance. Now, the behaviour is the following : Packets come from on-prem --> Gateway--> Subnets(01,02,03) then from Subnet(01,02,03) --> Virtual Appliance --> Gateway --> On-prem

My question is the following : How can we configure the routing table of the gateway ?


Regards, Samir Farhat || Datacenter Consultant || The way to share my knowledge with the communityVisit my blog : buildwindows.wordpress.com



Viewing all articles
Browse latest Browse all 6513

Trending Articles